TP-Link EAP115-Wall · 2.4 GHz wall-plate access point
Bring room Wi-Fi to a wired wall box
The EAP115-Wall turns an Ethernet run into a compact in-room 2.4 GHz access point. It fits compatible wall boxes and takes power over Ethernet, so the wall plate can sit close to a desk or bedside table without an extra wall adapter.

Fitting
Mount the access point at the wall
This low-profile unit fits a compatible EU-type data wall box. Check the box depth and cable bend before fitting it. Connect the uplink to an IEEE 802.3af PoE source.
Room networking
Use Wi-Fi and the room’s wired connection
The 2.4 GHz radio has a theoretical signal rate up to 300 Mbps. Two 10/100 Ethernet ports serve the wired side, so the uplink’s rated speed and local conditions limit usable throughput.
Guest access
Manage separate networks for different uses
Configure supported SSIDs, guest portal authentication, rate settings and wireless scheduling using a compatible TP-Link interface. TP-Link describes centralized management through compatible Omada hardware or software controllers. Check the exact revision and controller support first.







Reviews
There are no reviews yet.